XN1: Our New Cold Air Intake for the MINI N14 and N18

Meet the XN1: our new cold air intake for the MINI N14 and N18. It’s designed for cars that keep their MAF sensor, and the first run is limited to 100 kits.

The AIRIFIX XN1 cold air intake: ABS cover and PA6-CF carbon-fibre nylon pipe
The XN1: a one-piece ABS cover over a PA6-CF pipe

Why we made it

Our air filter relocation kit has been on plenty of Gen 2 MINIs, but it doesn’t suit cars with a MAF sensor or the N18 engine. We kept getting asked for something that did. The XN1 is that answer: a sealed cold air intake built around the MAF-equipped N14 and N18.

The XN1 launch graphic showing where it fits in the engine bay
Where the XN1 sits in the engine bay

What’s in the kit

  • A one-piece cover (box and seal) printed in ABS
  • A pipe printed in PA6-CF, a carbon-fibre reinforced nylon that’s stiff and copes with engine bay heat
  • A foam filter, fitted last through the rear opening
  • A rubber seal and a mounting bracket

Design details

  • Angled spigot. The outlet rises 15ยฐ to line up with the standard intake pipe, so there’s no strain on the joint.
  • Slide-off cover. The cover slides rearward off the pipe, so you can get to the filter without unbolting the whole kit.
  • One drain. A single drain at the bottom of the box lets any water out.
  • Clean finish. The XN1 logo is raised on top, and the inside edges are chamfered to keep the airflow smooth.
The XN1 cover slid off the PA6-CF pipe
The cover slides off rearward to reach the filter
The XN1 from above, with the raised logo on top
From above, with the raised XN1 logo

How the air moves

While designing it, we modelled the airflow through the kit at full load. In that model the air slows to around 5 m/s in the box and passes gently through the filter, then speeds up to around 45 m/s in the spigot on its way to the engine.

This is an indicative model of the airflow path. It’s not a full CFD study or a dyno result, and we’re not claiming a power gain from it.

Indicative airflow model through the XN1
Indicative airflow model: blue is slow, red is fast

First run: 100 kits

The first run is limited to 100 kits. If you’d like one, get in touch to register your interest and we’ll let you know as soon as they’re ready. Price and launch date to follow.

Fits: MINI Cooper S and JCW with the N14 or N18 engine and a MAF sensor. Not sure which you have? Message us with your registration and we’ll check.

Your Cart

No products in the cart.